BMW K 1200 LT 1999 Repair Manual page 186

Installing clutch housing
•
Lightly oil the internal spline (2).
•
Install thrust washer (1) between output shaft
and intermediate flange; apply a blob of grease
to hold the thrust washer in place, if necessary.
•
Fit the clutch housing (2).
2
1
11 2 500
11 2 821
KL110240
2
•
Fit the mounting fixture, BMW No. 11 2 821, on
the clutch housing at the position illustrated.
e
Caution:
Fit new nuts (5).
•
Fit a new O-ring (3) and thrust ring (4).
•
Tighten nut (5) with the collar facing outwards
(140 Nm).
•
Loosen nut and retighten (50 Nm).
•
Tighten nut with angle of rotation indicator,
BMW No. 11 2 500.
•
Remove the retaining fixture,
BMW No. 11 2 821.
X
Tightening torque:
1. Clutch housing nut ................................. 140 Nm
2. Slacken ...............................................................
3. Retighten to ............................................. 50 Nm
4. Wrench angle ................................................ 60°
3
4
5
KL210020
21.7