BMW K 1200 LT 1999 Repair Manual page 190

Removing and installing vent line
•
Unscrew the banjo bolt (1) on the clutch slave
cylinder.
•
Remove sealing rings (3) and vent line (2).
•
Assembly is the reverse of the disassembly pro-
cedure: pay particular attention to the following.
e
Caution:
Route the vent line without kinks such that contact
with the spring strut is not possible in any situation.
Always use new sealing rings (3).
•
Fill clutch system with brake fluid.
•
Bleed the clutch.
•
Secure the vent line to the right skirt
bracket (arrow) with a cable tie.
1
4
•
Return the clutch-lever fitting to the marked
position (4).
Brake fluid grade .........................................DOT 4
X
Tightening torque:
Grub screw .................................................. 10 Nm
Banjo bolt....................................................... 7 Nm
2
3
KL210230
KL000260
21.11