Removing And Installing Front Abs Sensor - BMW K 1100 LT/RS Repair Manual

Removing and installing front ABS
sensor
•
Remove fuel tank.
•
Disconnect plug connection (1) of sensor line.
•
Remove cover for brake distributor.
•
Remove rear section of mudguard.
•
Detach cable clips.
•
Release sensor (2) with Torx socket,
BMW No. 34 2 500.
•
Install in the reverse order of removal.
L
Note:
Carefully install the sensor line (arrow), note position
and number of cable clips and ensure tyre can turn
smoothly.
Check sensor spacing where the gap is largest; if
necessary readjust with spacer plate (3).
Sensor spacing
Up to 1996 MY............................... 0.50 - 0.55 mm
From 1997 MY ............................... 0.45 - 0.55 mm
X
Tightening torque:
Sensor to fork slider tube .............................. 4 Nm
34.10
1
2
3
LT340070