Installing And Removing Ex4300 Switch Hardware Components; Figure 47: Mounting The Switch On A Wall - Juniper EX4300 Hardware Manual

EX4300 Switch Hardware Guide
Related
Documentation

Installing and Removing EX4300 Switch Hardware Components

176

Figure 47: Mounting the Switch on a Wall

Rear panel
Hang attached brackets
on wall-mounted screws.
Tighten the mounting screws by using the screwdriver.
5.
Connecting AC Power to an EX4300 Switch on page 185
Connecting DC Power to an EX4300 Switch on page 188
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 215
Connecting and Configuring an EX Series Switch (J-Web Procedure) on page 218
Wall-Mounting Warning for EX4300 Switches on page 298
The EX4300 switch chassis is a rigid sheet-metal structure that houses the hardware
components. The field-replaceable units (FRUs) in EX4300 switches are:
Power supplies
Fan modules
Uplink module
Transceiver
The power supply (AC or DC), fan module, uplink module, and transceivers are
hot-removable and hot-insertable: You can remove and replace them without powering
off the switch or disrupting switch functions.
NOTE: You must remove a fan module only for replacement.
See these topics for instructions for installing and removing components:
Front
panel
Copyright © 2017, Juniper Networks, Inc.