Lcd Panel Modes; Figure 12: Lcd Panel In Ex4300 Switches - Juniper EX4300 Hardware Manual

EX4300 Switch Hardware Guide

LCD Panel Modes

28
the switch and also provides a menu to perform basic operations such as initial setup
and reboot.
There are two navigation buttons—Menu and Enter—to the right of the LCD panel.
See Figure 12 on page 28.

Figure 12: LCD Panel in EX4300 Switches

1— LCD panel
2— LCD panel Enter button
The first line of text on the LCD panel displays basic information about the switch and
the second line of text displays information about the mode selected on the LCD panel.
You can configure the second line of the text for the LCD panel to display a custom
message. If the LCD panel is configured to display a custom message, the Menu button
and the Enter button are disabled. See
(CLI Procedure)" on page
The LCD panel has a backlight. If the LCD panel is idle for 60 seconds, the backlight turns
off. You can turn on the backlight by pressing the Menu or Enter button once. After turning
on the backlight, you can toggle between the LCD panel menus by pressing the Menu
button and navigate through the menu options by pressing the Enter button.
NOTE: The chassis viewer in the J-Web interface also displays the LCD panel.
From the J-Web interface, you can view real-time status information in the
LCD panel. See
This topic describes:
LCD Panel Modes on page 28
LCD Panel Menus on page 29
The LCD panel operates in four modes: boot, idle, status, and maintenance.
The first line of text on the LCD panel displays the slot number, the role of the switch,
and hostname in all the modes.
For a standalone EX4300 switch, by default the slot number is
In an EX4300 switch that is a member of a Virtual Chassis, the first line of the LCD panel
always displays:
3— LCD panel Menu button
4— Chassis status LEDs
"Configuring the LCD Panel on EX Series Switches
223.
"Dashboard for EX Series Switches" on page 65.
, and the role is
00
Copyright © 2017, Juniper Networks, Inc.
.
RE