Figure 17: 8-Port 10-Gigabit Ethernet Sfp+ Uplink Module; Figure 18: Leds On The 8-Port 10-Gigabit Ethernet Sfp+ Uplink Module - Juniper EX4300 Hardware Manual

Table 16: Uplink Modules Used in 32-Port EX4300 Switches (continued)
Uplink Module Name
8-port 10-Gigabit Ethernet SFP+
uplink module
Copyright © 2017, Juniper Networks, Inc.
Model Number
EX-UM-8X8SFP
NOTE: When you install an uplink module in the switch or replace an uplink
module with another uplink module, the switch detects the ports on the uplink
module. The switch creates the required interfaces when transceivers are
installed in these ports.
The SFP+ uplink module ports can operate either in 10-gigabit or in 1-gigabit mode
depending on the transceiver you install in them. The operating mode for an SFP+ uplink
module is shown in the output of the
command.
number
Each port on the uplink modules has a pair of LEDs that indicate the link activity and
status of the port. See "Network Port, Built-In QSFP+ Port, Uplink Port, and Uplink Module
Chapter 2: Chassis Components and Descriptions
Figure
Figure 17: 8-Port 10-Gigabit Ethernet
SFP+ Uplink Module
Figure 18: LEDs on the 8-Port 10-Gigabit
Ethernet SFP+ Uplink Module
1. Status LED of the uplink module
2. Link activity LED of the lower port
3. Link activity LED of the upper port
4. Status LED the lower port
5. Status LED the upper port
show chassis pic fpc-slot slot number pic-slot slot
35