Understanding Ex Series Switches Fiber-Optic Cable Signal Loss, Attenuation; And Dispersion; Signal Loss In Multimode And Single-Mode Fiber-Optic Cable; Attenuation And Dispersion In Fiber-Optic Cable - Juniper EX4300 Hardware Manual

Table 77: Specifications of Cables to Connect to Management Devices (continued)
Ports
Management ( )
MGMT
Ethernet port (10/100/1000)
Mini-USB Type-B Console
( ) port
CON1
Understanding EX Series Switches Fiber-Optic Cable Signal Loss, Attenuation, and
Dispersion

Signal Loss in Multimode and Single-Mode Fiber-Optic Cable

Attenuation and Dispersion in Fiber-Optic Cable

Copyright © 2017, Juniper Networks, Inc.
Cable Specifications
–
–
To determine the power budget and power margin needed for fiber-optic connections,
you need to understand how signal loss, attenuation, and dispersion affect transmission.
EX Series Switches use various types of network cable, including multimode and
single-mode fiber-optic cable.
Signal Loss in Multimode and Single-Mode Fiber-Optic Cable on page 147
Attenuation and Dispersion in Fiber-Optic Cable on page 147
Multimode fiber is large enough in diameter to allow rays of light to reflect internally
(bounce off the walls of the fiber). Interfaces with multimode optics typically use LEDs
as light sources. However, LEDs are not coherent light sources. They spray varying
wavelengths of light into the multimode fiber, which reflects the light at different angles.
Light rays travel in jagged lines through a multimode fiber, causing signal dispersion.
When light traveling in the fiber core radiates into the fiber cladding (layers of lower
refractive index material in close contact with a core material of higher refractive index),
higher-order mode loss (HOL) occurs. Together, these factors reduce the transmission
distance of multimode fiber compared to that of single-mode fiber.
Single-mode fiber is so small in diameter that rays of light reflect internally through one
layer only. Interfaces with single-mode optics use lasers as light sources. Lasers generate
a single wavelength of light, which travels in a straight line through the single-mode fiber.
Compared to multimode fiber, single-mode fiber has a higher bandwidth and can carry
signals for longer distances. It is consequently more expensive.
Exceeding the maximum transmission distances can result in significant signal loss, which
causes unreliable transmission. For information about the maximum transmission distance
and supported wavelength range for the types of single-mode and multimode fiber-optic
cables that are used on different EX Series switches see
Supported on EX Series Switches" on page
An optical data link functions correctly provided that modulated light reaching the receiver
has enough power to be demodulated correctly. Attenuation is the reduction in strength
of the light signal during transmission. Passive media components such as cables, cable
Chapter 8: Transceiver and Cable Specifications
Receptacle
–
–
"Pluggable Transceivers
133.
Additional Information
"Connecting a Device to a
Network for Out-of-Band
Management" on page 193
147