Juniper EX4300 Hardware Manual page 244

EX4300 Switch Hardware Guide
Related
Documentation
222
Select this option to configure only the management interface. Click
the IP address and default gateway for the management interface.
Click Next .
8.
On the Manage Access page, you can select options to enable Telnet, SSH, and SNMP
9.
services. For SNMP, you can configure the read community, location, and contact.
Click . The Summary screen displays the configured settings.
Next
10.
Click . The configuration is committed as the active switch configuration.
Finish
11.
NOTE: After the configuration is committed, the connectivity between
the PC and the switch might be lost. To renew the connection, release and
renew the IP address by executing the appropriate commands on the
management PC or by removing and reinserting the Ethernet cable.
(For EX4500 switches only) In the CLI, enter the request chassis pic-mode
12.
intraconnect operational mode command to set the PIC mode to intraconnect.
You can now log in by using the CLI or the J-Web interface to continue configuring the
switch.
If you use the J-Web interface to continue configuring the switch, the Web session is
redirected to the new management IP address. If the connection cannot be made, the
J-Web interface displays instructions for starting a J-Web session.
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 215
Installing and Connecting an EX2200 Switch
Installing and Connecting an EX3200 Switch
Installing and Connecting an EX3300 Switch
Installing and Connecting an EX4200 Switch
Installing and Connecting an EX4300 Switch on page 165
Installing and Connecting an EX4500 Switch
Installing and Connecting an EX4550 Switch
Installing and Connecting an EX4600 Switch
Installing and Connecting an EX6210 Switch
Installing and Connecting an EX8208 Switch
Installing and Connecting an EX8216 Switch
. Specify
Next
Copyright © 2017, Juniper Networks, Inc.