Juniper EX4300 Hardware Manual page 173

Related
Documentation
Copyright © 2017, Juniper Networks, Inc.
RE-USB-1G-S
RE-USB-2G-S
RE-USB-4G-S
CAUTION: Any USB memory product not listed as supported for EX Series
switches has not been tested by Juniper Networks. The use of any
unsupported USB memory product could expose your EX Series switch to
unpredictable behavior. Juniper Networks Technical Assistance Center (JTAC)
can provide only limited support for issues related to unsupported hardware.
We strongly recommend that you use only supported USB flash drives.
All USB flash drives used on EX Series switches must have the following features:
USB 2.0 or later.
Formatted with a FAT or MS-DOS file system.
If the switch is running Junos OS Release 9.5 or earlier, the formatting method must
use a master boot record. Microsoft Windows formatting, by default, does not use a
master boot record. See the documentation for your USB flash drive for information
about how your USB flash drive is formatted.
EX2200 Switches Hardware Overview
EX2300 Switches Hardware Overview
Rear Panel of an EX3200 Switch
Rear Panel of an EX3300 Switch
Rear Panel of an EX3400 Switch
Rear Panel of an EX4200 Switch
EX4300 Switches Hardware Overview on page 3
Front Panel of an EX4500 Switch
Management Panel of an EX4600 Switch
EX4550 Switches Hardware Overview
Switch Fabric and Routing Engine (SRE) Module in an EX6200 Switch
Switch Fabric and Routing Engine (SRE) Module in an EX8208 Switch
Routing Engine (RE) Module in an EX8216 Switch
Routing Engine Module in an EX9200 Switch
Booting an EX Series Switch Using a Software Package Stored on a USB Flash Drive
Chapter 9: Pinout Specifications
151