Uplink Modules In Ex4300 Switches - Juniper EX4300 Hardware Manual

Table 12: LCD Panel Menu Options in EX4300 Switches (continued)
Menu Label Description
MAINT The Maintenance menu has the following options to configure and troubleshoot the switch:
(Maintenance
SYSTEM HALT?—Choose one of the following:
Menu)
Press Enter to halt the switch. Press Enter again to confirm the halt.
Press Menu to go to the next option in the Maintenance menu.
SYSTEM REBOOT?—Choose one of the following:
Press Enter to reboot the switch. Press Enter again to confirm the reboot.
Press Menu to go to the next option in the Maintenance menu.
LOAD RESCUE?—Choose one of the following:
Press Enter to roll back the switch to the previous valid configuration. Press Enter again to confirm the
rollback.
Press Menu to go to the next option in the Maintenance menu.
REQUEST VC PORT?—Choose one of the following:
Press the Enter button to configure an uplink module port or a built-in QSFP+ port to be a VCP or to
delete a VCP from the switch configuration (when you delete the VCP, the port is reset to be an uplink
module port or a network port).
Press the Menu button to go to the next option in the Maintenance menu.
FACTORY DEFAULT?—Choose one of the following:
Press Enter to restore the switch to the factory default configuration. Press Enter again to confirm the
restoration. The LCD panel flashes a success or failure message, after which it displays the Idle menu.
Press Menu to go to the next option in the Maintenance menu.
ENTER EZSETUP?—Choose one of the following:
Press Enter to launch EZSetup. Press Enter again to confirm the launch.
EZSetup configures DHCP and enables the J-Web user interface on the switch. The LCD panel flashes
a success or failure message for approximately 10 seconds, after which it displays the Idle menu.
NOTE:
For information about EZSetup, see
Procedure)" on page
Press Menu to go to the next option in the Maintenance menu.
EXIT MAINT MENU?—Choose one of the following:
Press Enter to exit the Maintenance menu.
Press Menu to return to the SYSTEM HALT? option.
You can disable the Maintenance menu or the options in the Maintenance menu in the LCD panel. See
"Configuring the LCD Panel on EX Series Switches (CLI Procedure)" on page
Related
Documentation

Uplink Modules in EX4300 Switches

Copyright © 2017, Juniper Networks, Inc.
You can use EZSetup only on a standalone switch that is in the factory default configuration.
218.
EX4300 Switches Hardware Overview on page 3
Connecting and Configuring an EX Series Switch (CLI Procedure) on page 215
EX4300 switches provide a slot to install an optional uplink module. Uplink modules are
hot-insertable and hot-removable field-replaceable units (FRUs).
Chapter 2: Chassis Components and Descriptions
"Connecting and Configuring an EX Series Switch (J-Web
223.
31