Display {Ap | Dap} Status - 3Com WX4400 Command Reference Manual

310 C 11: M
HAPTER
display {ap | dap}
status
A P C
ANAGED CCESS OINT OMMANDS
Table 54 Output for display ap group
Field
Load Balance Grp
Port
Clients
Status
Refused
See Also
set {ap | dap} group on page 351
Displays MAP access point and radio status information.
Syntax — display ap status [terse] [port-list | all [radio
{1 | 2}]]
Syntax — display dap status [terse] [dap-num [radio {1 |
2}]]
terse — Displays a brief line of essential status information for each
MAP.
port-list
which to display status.
dap-num — Number of a Distributed MAP for which to display status.
all — Shows status information for all directly attached MAP access
points and all Distributed MAP access points configured on the switch.
radio 1 — Shows status information for radio 1.
radio 2 — Shows status information for radio 2. (This option does
not apply to single-radio models.)
Defaults — None.
Description
Name of the MAP access point group.
WX port number.
Number of active client sessions on the MAP access point.
Association status of the MAP access point:
Accepting — The MAP access point is accepting new
associations.
Refusing — The MAP access point is refusing new
associations.
Number of association requests refused by the MAP access
point due to load balancing. MSS resets this counter to 0
when the WX switch is restarted, MSS is reloaded, or the
access point is removed from the group.
— List of ports connected to the MAP access point(s) for