3Com WX4400 Command Reference Manual page 316

316 C 11: M
HAPTER ANAGED
A P C
CCESS OINT OMMANDS
Table 55 Output for display ap status (continued)
Field
Radio 1 type
Radio 2 type
(cont.)
operational channel
operational power
base mac
bssid, ssid
Table 56 Output for display ap status terse and display dap status terse
Field
Port
Flg
IP Address
Model
MAC Address
Radio1
Description
The following information appears for external antennas:
External antenna detected, configured as
antenna-model—Indicates that an external antenna has
been detected, and lists the antenna model configured
on the radio. (MSS does not detect the specific model.)
External antenna detected, not configured—Indicates
that an external antenna was detected but no external
antenna is configured on the radio.
External antenna not detected, configured as
antenna-model—Indicates that an external antenna is
configured on the radio but no external antenna was
detected.
The channel on which the radio is currently operating.
If the channel number is followed by (Auto), the value was
set by RF Auto-Tuning.
The power level at which the radio is currently operating.
If the power setting is followed by (Auto), the value was set
by RF Auto-Tuning.
Base MAC address of the radio.
SSIDs configured on the radio and their BSSIDs.
Description
WX port number connected to the MAP.
Operational status flags for the MAP.
For flag definitions, see the key in the command output.
IP address of the MAP. The address is assigned to the MAP by
a DHCP server.
This field is applicable only if the MAP is configured on the
WX switch as a Distributed MAP.
MAP model number.
MAC address of the MAP.
State, channel, and power information for radio 1:
The state can be D (disabled) or E (enabled).
The channel and power settings are shown as
channel/power.