Diag; Dir - 3Com WX4400 Command Reference Manual

diag

dir

Examples — The following command displays the current setting of the
DHCP option:
boot> dhcp
DHCP is currently enabled.
The following command disables the DHCP option:
boot> dhcp
DHCP is currently disabled.
See Also
boot on page 671
Accesses the diagnostic mode.
Syntax — diag
Defaults — The diagnostic mode is disabled by default.
Access — Boot prompt.
History —Introduced in MSS Version 3.0.
Usage — Access to the diagnostic mode requires a password, which is
not user configurable. Use this mode only if advised to do so by 3Com.
Displays the boot code and system image files on a WX switch.
Syntax —
dir [c: | d: | e: | f: | boot0 | boot1]
— Nonvolatile storage area containing boot partition 0 (primary).
c:
— Nonvolatile storage area containing boot partition 1 (secondary).
d:
— Primary partition of the flash card in the flash card slot.
e:
— Secondary partition of the flash card in the flash card slot.
f:
— Boot partition 0.
boot0
— Boot partition 1.
boot1
Defaults — None.
diag 677