Radius And Server Group Commands; Commands By Usage - 3Com WX4400 Command Reference Manual

16
Commands by
Usage
RADIUS
C
OMMANDS
Use RADIUS commands to set up communication between a WX switch
and groups of up to four RADIUS servers for remote authentication,
authorization, and accounting (AAA) of administrators and network
users.
This chapter presents RADIUS commands alphabetically. Use Table 85 to
locate commands in this chapter based on their uses.
Table 85 RADIUS Commands by Usage
Type Command
RADIUS Client set radius client system-ip on page 536
clear radius client system-ip on page 531
RADIUS Servers set radius on page 534
set radius server on page 539
clear radius on page 530
clear radius server on page 533
Server Groups set server group on page 541
set server group load-balance on
page 542
clear server group on page 533
RADIUS Proxy set radius proxy client on page 537
set radius proxy port on page 538
clear radius proxy client on page 532
clear radius proxy port on page 532
(For information about RADIUS attributes, see the RADIUS appendix in
the Wireless LAN Switch and Controller Configuration
S
AND ERVER
G
ROUP
Guide.)