3Com WX4400 Command Reference Manual page 86

86 C 4: P
HAPTER ORT
C
OMMANDS
— Number for the Distributed MAP. The range of valid
dap-num
connection numbers depends on the WX switch model:
For a WX4400, you can specify a number from 1 to 256.
For a WX1200, you can specify a number from 1 to 30.
serial-id serial-ID
listed on the MAP case. To show the serial ID using the CLI, use the
display version details command.
radiotype 11a | 11b| 11g
— 802.11a
11a
— 802.11b
11b
11g — 802.11g
This option applies only to single-radio models.
Defaults — The default values are the same as the defaults for the
set port type ap command.
Access — Enabled.
History — Introduced in MSS Version 3.0. New values for model option
added in Version 4.1:
AP3750
AP2750
mp-620
Examples — The following command configures Distributed MAP 1 for
MAP model AP2750 with serial-ID M9DE48B012F00:
WX4400# set dap 1 serial-id M9DE48B012F00 model ap2750
success: change accepted.
The following command removes Distributed MAP 1:
WX4400# clear dap 1
This will clear specified DAP devices.
Would you like to continue? (y/n) [n]y
See Also
clear dap on page 68
— MAP access point serial ID. The serial ID is
— Radio type: