Set Dot1X Wep-Rekey - 3Com WX4400 Command Reference Manual

set dot1x
wep-rekey
Examples — Type the following command to set the number of seconds
before the WX switch retransmits an EAPoL packet to 300:
WX4400# set dot1x tx-period 300
success: dot1x tx-period set to 300.
See Also
display dot1x on page 551
clear dot1x tx-period on page 551
Enables or disables Wired Equivalency Privacy (WEP) rekeying for
broadcast and multicast encryption keys.
Syntax —
set dot1X wep-rekey {enable | disable}
enable — Causes the broadcast and multicast keys for WEP to be
rotated at an interval set by the set dot1x wep-rekey-period for each
radio, associated VLAN, and encryption type. The WX generates the
new broadcast and multicast keys and pushes the keys to the clients
via EAPoL key messages.
disable — WEP broadcast and multicast keys are never rotated.
Defaults — WEP key rotation is enabled, by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — Reauthentication is not required for WEP key rotation to take
place. Broadcast and multicast keys are always rotated at the same time,
so all members of a given radio, VLAN, or encryption type receive the
new keys at the same time.
Examples — Type the following command to disable WEP key rotation:
WX4400# set dot1x wep-rekey disable
success: wep rekeying disabled
See Also
display dot1x on page 551
set dot1x wep-rekey-period on page 564

set dot1x wep-rekey

563