Set Radio-Profile Auto-Tune Channel-Interval - 3Com WX4400 Command Reference Manual

set radio-profile
auto-tune
channel-interval
Usage — The channel holddown applies even if RF anomalies occur that
normally cause an immediate channel change.
Examples — The following command changes the channel holddown
for radios in radio profile rp2 to 600 seconds:
WX4400# set radio-profile rp2 auto-tune channel-holddown 600
success: change accepted.
See Also
display radio-profile on page 327
set radio-profile auto-tune channel-config on page 367
set radio-profile auto-tune channel-interval on page 369
Sets the interval at which RF Auto-Tuning decides whether to change the
channels on radios in a radio profile. At the end of each interval, MSS
processes the results of the RF scans performed during the previous
interval, and changes radio channels if needed.
Syntax — set radio-profile name auto-tune channel-interval
seconds
name — Radio profile name.
seconds — Number of seconds RF Auto-Tuning waits before
changing radio channels to adjust to RF changes, if needed. You can
specify from 0 to 65535 seconds.
Defaults — The default channel interval is 3600 seconds (one hour).
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — 3Com recommends that you use an interval of at least 300
seconds (5 minutes).
RF Auto-Tuning can change a radio's channel before the channel interval
expires in response to RF anomalies. Even in this case, channel changes
cannot occur more frequently than the channel holddown interval.

set radio-profile auto-tune channel-interval

369