Set Ntp - 3Com WX4400 Command Reference Manual

set ntp

display ip https on page 149
display ip telnet on page 152
set ip https server on page 171
set ip telnet on page 175
Enables or disables the NTP client on a wireless LAN switch.
Syntax —
set ntp {enable | disable}
— Enables the NTP client.
enable
— Disables the NTP client.
disable
Defaults — The NTP client is disabled by default.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — If NTP is configured on a system whose current time differs
from the NTP server time by more than 10 minutes, convergence of the
WX time can take many NTP update intervals. 3Com recommends that
you set the time manually to the NTP server time before enabling NTP to
avoid a significant delay in convergence.
Examples — The following command enables the NTP client:
WX4400# set ntp enable
success: NTP Client enabled
See Also
clear ntp server on page 135
clear ntp update-interval on page 136
display ntp on page 153
set ntp server on page 178
set ntp update-interval on page 179
set ntp 177