3Com WX4400 Command Reference Manual page 348

348 C 11: M
HAPTER ANAGED
A P C
CCESS OINT OMMANDS
History —Introduced in MSS 4.2.
Usage — When you specify a boot switch for a distributed MAP to boot
from, it boots using the process described in "MAP Boot Process Using
Static IP Configuration", in the
Configuration Guide.
When a static IP address is specified for a Distributed MAP, there is no
preconfigured DNS information or DNS name for the WX switch the
Distributed MAP attempts to use as its boot device. If you configure a
static IP address for a Distributed MAP, but do not specify a boot device,
then the WX switch must be reachable via subnet broadcast.
Examples — The following command configures Distributed MAP 1 to
use the WX switch with address 172.16.0.21 as its boot device.
WX1200# set dap 1 boot-switch switch-ip 172.16.0.21 mode
enable
success: change accepted.
The following command configures Distributed MAP 1 to use the WX
switch with the name mxr2 as its boot device. The DNS server at
172.16.0.1 is used to resolve the name of the WX switch.
WX4400# set dap 1 boot-switch name mxr2 dns 172.16.0.1 mode
enable
success: change accepted.
See Also
clear dap boot-configuration on page 293
display dap boot-configuration on page 321
set dap boot-ip on page 346
set dap boot-vlan on page 349
Wireless LAN Switch and Controller