Trace; Commands By Usage - 3Com WX4400 Command Reference Manual

21
Commands by
Usage
T C
RACE OMMANDS
Use trace commands to perform diagnostic routines. While MSS allows
you to run many types of traces, this chapter describes commands for
those traces you are most likely to use. For a complete listing of the types
of traces MSS allows, type the set trace ? command.
CAUTION: Using the set trace command can have adverse effects on
system performance. 3Com recommends that you use the lowest levels
possible for initial trace commands, and slowly increase the levels to get
the data you need.
This chapter presents trace commands alphabetically. Use Table 108 to
locate commands in this chapter based on their use.
Table 108 Trace Commands by Usage
Type Command
Trace set trace sm on page 645
set trace dot1x on page 644
set trace authentication on page 642
set trace authorization on page 643
display trace on page 641
save trace on page 642
clear trace on page 640
clear log trace on page 640