Set Dap Auto Persistent - 3Com WX4400 Command Reference Manual

set dap auto
persistent
Converts a temporary MAP configuration created by the MAP
configuration profile into a persistent MAP configuration on the WX
switch.
Syntax —

set dap auto persistent

— Converts the configuration of the Distributed MAP that
dap-num
has the specified connection number into a permanent configuration.
— Converts the configurations of all Auto-APs being managed by
all
the switch into permanent configurations.
Defaults — None.
Access — Enabled.
History —Introduced in MSS 4.0.
Usage — To display the Distributed MAP numbers assigned to
Auto-MAPs, use the display dap status auto command.
Examples — The following command converts the configuration of
Auto-AP 10 into a permanent configuration:
WX4400# set dap auto persistent 10
success: change accepted.
See Also
set dap auto on page 339
set dap auto mode on page 342
set dap auto radiotype on page 342
set dap auto persistent
[dap-num | ]
all
341