3Com WX4400 Command Reference Manual page 355

— Maximum power setting RF Auto-Tuning can assign
power-level
to the radio, expressed as the number of decibels in relation to 1
milliwatt (dBm). You can specify a value from 1 up to the maximum
value allowed for the country of operation.
The power-level can be a value from 1 to 20.
Defaults — The default maximum power setting that RF Auto-Tuning
can set on a radio is the highest setting allowed for the country of
operation or highest setting supported on the hardware, whichever is
lower.
Access — Enabled.
History —Introduced in MSS Version 3.0. Option auto added for
configuration of the MAP configuration profile.
Examples — The following command sets the maximum power that
RF Auto-Tuning can set on radio 1 on the MAP access point on port 6 to
12 dBm.
WX1200# set ap 6 radio 1 auto-tune max-power 12
success: change accepted.
See Also
set {ap | dap} radio auto-tune max- retransmissions on page 356
set radio-profile auto-tune power-backoff- timer on page 370
set radio-profile auto-tune power-config on page 371
set radio-profile auto-tune power-interval on page 372
set {ap | dap} radio auto-tune max-power 355