Set Port Speed - 3Com WX4400 Command Reference Manual

WX1200# set port poe 4,5 disable
If you are enabling power on these ports, they must be connected only to approved
PoE devices with the correct wiring. Do you wish to continue? (y/n) [n]y
WX1200# set port poe 4,5 enable
If you are enabling power on these ports, they must be connected only to approved
PoE devices with the correct wiring. Do you wish to continue? (y/n) [n]y

set port speed

Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — This command does not apply to any gigabit Ethernet ports or
to ports 7 and 8 on the WX1200 switch.
Examples — The following command disables PoE on ports 4 and 5,
which are connected to a MAP access point:
The following command enables PoE on ports 4 and 5:
See Also
set port type ap on page 95
set port type wired-auth on page 98
Changes the speed of a port.
Syntax — set port speed port-list {10 | 100 | 1000 | auto}
port-list — List of physical ports. MSS sets the port speed on all the
specified ports.
10 — Sets the port speed of a 10/100 Ethernet port to 10 Mbps and
sets the operating mode to full-duplex.
100 — Sets the port speed of a 10/100 Ethernet port to 100 Mbps
and sets the operating mode to full-duplex.
1000 — Sets the port speed of a gigabit Ethernet port to 1000 Mbps
and sets the operating mode to full-duplex.
— Enables a port to detect the speed and operating mode of the
auto
traffic on the link and set itself accordingly.
Defaults — All ports are set to auto.
Access — Enabled.
set port speed 93