Paper End Detection (Fan-Fold Media) - SATO CW408 Operator's Manual

Preliminary
8.5 PAPER END (Cont'd)
[ When the media pitch size is between the head position and the paper end sensor and is more than 15 mm
(0.6").]
The printer behavior when paper end is detected is as follows:
• "Paper end error" will occur while printing the media (1), right after detecting "paper end".
• If an error occurs while printing, media (1) will be printed again after releasing the error. If the print job is
completed at the time of error occurrence, media (1) will not be printed again.

8.5.3 Paper End Detection (Fan-fold Media)

The printer behavior when paper end is detected is as follows:
• "Paper end error" will occur after printing the media (2) and feed media 50 mm (1.9").
• If an error occurs while printing or feeding 50 mm (1.9") after printing, media (2) will be printed again after
releasing the error. If the print job is completed at the time of error occurrence, media (2) will not be printed
again.
• In cutter mode, cut operation is not performed when "paper end error" occurs.
• When "ignore pitch sensor" is set, the paper end sensor will detect "No media" state and notify paper end
error after feeding the media 15 mm (0.6").
CW408 Operator Manual
Head position
Media feed direction
I-mark
(1)
Media feed direction
49.9 mm (1.9")
(1)
(2)
Section 8: Appendix
Paper end sensor
15 mm
(0.6")
Feed 50 mm (1.9")
Page 8-9