Common Notes For Lan Interface - SATO CW408 Operator's Manual

Preliminary
7.3 LOCAL AREA NETWORK (LAN) ETHERNET (Cont'd)

7.3.8 Common Notes for LAN Interface

1.
For LAN interface setting, you can use the printer setting tool, such as SATO All-In-One application. Refer
to your SATO reseller or technical support center for more information. Or you can visit our SATO home
page at www.satoworldwide.com.
2.
When opening or closing the print data port (Port 1024) or the status port (Port 1025) or the sending and
receiving port (Port 9100), 150 ms to 200 ms interval is necessary between closing the port and opening
the port again.
If the time interval after closing the port is too short, it may cause double connection.
Double connection means that the connection request (CONNECT) is sent to the port (Port 1024, Port
1025 or Port 9100) already connected (CONNECT (Socket OPEN)). In this case, this connection request
will be rejected (Socket CLOSE).
3.
Connecting and disconnecting LAN cable while the printer is connecting to the PC may result in communi-
cation failure. Please avoid connecting or disconnecting the cable while the printer is ON. In case of
communication failure, restart the printer.
CW408 Operator Manual
Section 7: Interface Specifications
Page 7-7