SATO CW408 Operator's Manual page 56

Preliminary
Section 3: Operation and Configuration
3.14 TEST PRINT MODE (Cont'd)
Menu
TEST PRINT
MODE SELECT
TEST PRINT
USER TEST
MODE SELECT
TEST PRINT
SERVICE TEST
MODE SELECT
TEST PRINT
BARCODE
MODE SELECT
TEST PRINT
HEAD CHECK
MODE SELECT
TEST PRINT
FONTS
MODE SELECT
FACTORY
TEST PRINT
SIZE SELECT
LARGE SMALL
TEST PRINT
FEED - >PRINT
TEST PRINT
PRESS FEED KEY
Page 3-30
TEST PRINT MODE
Choosing the test print contents.
USER TEST: The configuration settings of the printer will be printed.
SERVICE TEST: This test print is for service engineer use.
BARCODE: The barcodes installed in this printer will be printed.
HEAD CHECK: The head check pattern of the selected media size area will be
printed.
FONTS: The contents of the fonts installed in this printer will be printed.
FACTORY: The factory test print will be performed.
The initial setting is USER TEST.
If you chose test prints of USER TEST, SERVICE TEST, BARCODE, HEAD
CHECK or FACTORY in the previous menu (except FONTS), this screen
appears for selecting print size. In this screen, you can choose to print the test
results in LARGE or SMALL print widths.
SMALL: Test print in 50 mm (1.97") wide
LARGE: Test print in 104 mm (4.09") wide
The initial setting is LARGE.
Test print is in progress
Press the FEED button to start printing.
Press the FEED button while printing to pause the test print operation. Press
the FEED button again to continue printing.
To exit the Test print mode
Make sure that the printer is in pause mode, press the
printer to off.
Description
CW408 Operator Manual
power button to set