SATO CW408 Operator's Manual page 69

Preliminary
3.16 SERVICE MODE (Cont'd)
Menu
MACHINE SETTING
AUTO LABEL FEED
ENABLE DISABLE
MACHINE SETTING
AUTO FEED POS
+ 00 dot
CW408 Operator Manual
MACHINE SETTING MODE
To set the Auto label feed function.
This function enables the printer to feed media automatically in online mode
after starting up the printer.
ENABLE: Feed the media in online mode after the printer is started up.
DISABLE: Does not feed the media in online mode after the printer is started
up.
The initial setting is ENABLE.
To adjust the Auto feed position.
Press the LINE button to change the setting value and press the FEED button
to move the cursor to next digit.
Setting range is between -99 to +99 dots.
The initial value is +00 dot.
Notes:
• This is to fine-tune the offset position of the first label after auto feed is com-
pleted.
• Make sure to check the actual operation when you adjust the position. Auto
feed may not work properly and label may fall off.
• Factory preset is set as default.
Default value is not initialized by executing factory all clear.
• You can confirm the settings by referring to the FACTORY ALF in FAC-
TORY TEST PRINT.
Section 3: Operation and Configuration
Description
Page 3-43