SATO CW408 Operator's Manual page 102

Preliminary
Section 7: Interface Specifications
7.3 LOCAL AREA NETWORK (LAN) ETHERNET (Cont'd)
7.3.1 Basic Specifications (Cont'd)
Communication
Configuration
Maximum Receive
Buffer Capacity
Page 7-4
The following communication settings are available in the Interface mode of the
printer.
Item
Protocol
IP address
Subnet mask
Gateway address
IP address setting
RARP setting
* IP address, Subnet mask, Gateway address can be set by printer setting tool,
such as SATO All-In-One application.
* If the printer cannot obtain IP address from DHCP server at DHCP enabled,
default of IP address becomes [0.0.0.0].
2.95 MB
0 MB
Buffer near full
occurred
Buffer near full
released
Setting Range
STATUS3
STATUS4 (Cyclic response mode)
STATUS4 (ENQ response mode) (Default)
0.0.0.0 ~ 255.255.255.255
Default: 192.168.1.1
0.0.0.0 ~ 255.255.255.255
Default:255.255.255.0
0.0.0.0 ~ 255.255.255.255
Default:0.0.0.0
DHCP Disable (Set by manual)
DHCP Enable
Default: Disable (Set by manual)
RARP Disable
RARP Enable
Default: Disable
Remaining 0.95 MB
Remaining 1.95 MB
CW408 Operator Manual
2.95 MB