SATO CW408 Operator's Manual page 83

Preliminary
5.1 ERROR SIGNAL TROUBLESHOOTING (Cont'd)
No. ERROR DISPLAY
14 DOWNLOAD DATA
ERROR
ERROR14
DOWNLOAD DATA E
15 CUTTER ERROR
ERROR15
CUTTER ERR
21 KANJI DATA ERROR
ERROR21
KANJI DATA
26 OVERHEAT ERROR
ERROR26
PRINTER OV
27 COMMAND ERROR
ERROR27
INVALID DATA
Caaa:<bb>:cc
CW408 Operator Manual
LED/ BUZZER
ONLINE: Off 1) Received invalid data.
ERROR: On 2) Not enough download
Message: DOWN-
LOAD DATA ERROR To clear error: Press the
FEED button
1 long beep
ONLINE: Off 1) Media was jammed at the
ERROR: Blinks
2) Cutter's blade does not
Message: CUTTER
ERROR
To clear error: Press the
3 short beeps
FEED button
ONLINE: Off 1) Reading invalid Kanji data
ERROR: On
Message: KANJI
DATA ERROR
To clear error: Power off
3 short beeps
ONLINE: Blinks 1) Printer's temperature is
ERROR: Blinks
Message: PRINTER
To clear error: Stop
OVERHEATED.
operating the printer and
PLEASE WAIT.
cool it down
1 long beep
ONLINE: Off 1) Invalid command or
ERROR: Blinks
Message: INVALID
2) Print ratio per media
DATA
3 short beeps
[Note]
• This screen appears
• Detected command
To clear error: Leave the
printer for a certain period.
Press the LINE button
ERROR CONDITION
area
cutter unit.
return to the original
position.
that was imported to Kanji
memory.
beyond the allowable
range.
parameter was found in
print data.
exceeded 50% (416 dots)
when using Print
darkness level B.
when setting [DISPLAY
ERROR] to "ENABLE".
information will be shown
at the bottom of the
screen.
Section 5: Troubleshooting
CORRECTIVE ACTION
1) Check downloaded data.
2) Check the size of downloaded
data.
1) Clean the cutter unit.
2) Press the FEED button and move
the cutter blade to the original
position.
1) Replace PCB board.
1) Stop operating the printer and let
it cool down.
1) Confirm print data.
2) Adjust print layout so that print
ratio is lower than 50%.
Page 5-3