To Set The Power To On; To Set The Power To Off - SATO CW408 Operator's Manual

Preliminary
2.2 CONNECTIONS (cont'd)

2.2.4 To Set the Power to On

Warning
Do not press the power button or insert/ remove the power cord while your hands are wet. Doing so may
cause an electric shock.
Press and hold the
of the printer for about a second.
The printer takes a few seconds to start up. The ONLINE
indicator displays green and the screen displays ONLINE.
Note:
If you have just connected the AC power cord, wait for
about ten seconds before you press the

2.2.5 To Set the Power to Off

When you have completed the printing job, set the printer to
off.
1.
Be sure to confirm that the printer is in the OFFLINE
mode. If not, press the LINE button to enter OFFLINE
mode.
Note:
If there is any printed media remaining in the printer,
press the FEED button to discharge the media.
2.
Press and hold the
turns off.
CW408 Operator Manual
power button on the operator panel
power button.
power button until the display
Section 2: Installation
ONLINE ERROR
ONLINE
000000
LINE
OFFLINE
000000
Page 2-5