SATO CW408 Operator's Manual page 45

Preliminary
3.10 INTERFACE SETTING MODE (Cont'd)
Menu
I/F SETTINGS
INTERFACE SELECT
I/F SETTINGS
AUTO SELECT
INTERFACE SELECT
I/F SETTINGS
USB
INTERFACE SELECT
LAN
I/F SETTINGS
PROTOCOL
I/F SETTINGS
STATUS4
PROTOCOL
STATUS3
I/F SETTINGS
REPLY TIMING
I/F SETTINGS
ENQ
REPLY TIMING
CYCLE
CW408 Operator Manual
I/F SETTINGS MODE
Select the connected interface.
AUTO SELECT, USB or LAN can be selected.
AUTO SELECT: The interface connected to the host becomes effective at
power on. When both LAN and USB are connected, USB becomes effective.
USB: Connects to only USB.
LAN: Connects to only LAN.
The initial setting is AUTO SELECT.
Select the communication protocol.
These screens are displayed only when using LAN.
STATUS3 and STATUS4 are available for selection.
The initial setting is STATUS4.
Set the timing for the host status reply.
These screens are displayed only when PROTOCOL is set to STATUS4.
ENQ: Returns status after receiving Status Request (ENQ), which is sent from
the host.
CYCLE: Returns status from the printer to the host at 900 ms intervals.
The initial setting is ENQ.
Section 3: Operation and Configuration
Description
Page 3-19