Automatic Media Feed (Disable); Notes For Automatic Media Feed - SATO CW408 Operator's Manual

Table of Contents

Preliminary

8.6 AUTOMATIC MEDIA FEED (Cont'd)

Notes (cont'd):

•

If you place the media 150 mm (5.9") ahead of the print head, an error will occur when closing the cover.

•

When the automatic media feed function is enabled in tear-off or cutter mode, the position of the first media

is not set correctly. Press the FEED button in offline mode to adjust the position.

8.6.2 Automatic Media Feed (Disable)

When automatic media feed setting is disabled, the printer does not feed media automatically. Open the cover

of the printer to set the media manually.

1. When setting the media with the cover open or when rebooting the printer, you have to set the first piece of

the media. When setting the first media, make sure that the I-mark or gap of label does not overlap the

paper sensor or I-mark sensor. (Sensor detection error or paper jam may occur when setting the media

other than the first.)

2. When setting the media for the automatic media feed, make sure that the paper sensor can detect the

media correctly. (For example, cut the perforated line of the media)

3. Make sure to set the new media as the printer is ready for printing after automatic media feed is com-

pleted. If you set a printed media, the printing overlaps the printed area of the media.

CW408 Operator Manual

Section 8: Appendix

Page 8-11

Table of Contents