How To Remove Media From The Printer - SATO CW408 Operator's Manual

Preliminary
Section 2: Installation
2.4 HOW TO LOAD THE MEDIA (cont'd)

2.4.2 How to Remove Media from the Printer

1.
Press the cover open latch
printer to open the top cover of the printer. The top
cover will open upwards.
2
2.
Then, flip the top cover
open.
Note:
Make sure that the cover rests firmly so that it will not fall
and injure your hands.
Caution
• After printing, the print head and its surrounding area are hot. Keep your fingers away from
these areas to prevent injury.
• Avoid touching even the edge of the print head with your bare hands.
3.
Remove the media from the media path of printer.
4.
Close the top cover and press the two front corners of
the top cover until a click sound is heard. Make sure
that the top cover is locked.
Note:
Be careful not to get your fingers pinched while closing
the top cover.
Page 2-8
on the right side of the
1
to the left until it is fully
3
2
1
3
CW408 Operator Manual