SATO CW408 Operator's Manual page 48

Preliminary
Section 3: Operation and Configuration
3.11 ADVANCE SETTINGS MODE (Cont'd)
Menu
ADVANCE SETTINGS
HEAD CHECK
ENABLE DISABLE
ADVANCE SETTINGS
HEAD CHECK
ADVANCE SETTINGS
STANDARD
HEAD CHECK
BARCODE
ADVANCE SETTINGS
HEAD CHECK MODE
ADVANCE SETTINGS
ALL
HEAD CHECK MODE
ADVANCE SETTINGS
CHECK LABELS
HEAD CHECK MODE
START-END
ADVANCE SETTINGS
CHECK LABELS
0 0 0 0 0 1
ADVANCE SETTINGS
AUTO ONLINE
ENABLE DISABLE
Page 3-22
ADVANCE SETTINGS MODE
The printer can be set to perform a check of the print head during printing oper-
ation.
ENABLE: Head check function is on.
Select ENABLE and press the FEED button to proceed to HEAD CHECK
menu.
DISABLE: Head check function is off.
Select DISABLE and press the FEED button to proceed directly to AUTO
ONLINE menu.
The initial setting is DISABLE.
If Head Check is set to ENABLE, you can specify the print head check range to
be performed unconditionally, or only when barcodes are being printed.
These screens are displayed only when HEAD CHECK is set to ENABLE.
STANDARD: Head check is performed on the entire print head.
BARCODE: Head check is performed only on position where barcodes are
being printed.
The initial setting is STANDARD.
Setting head check mode.
These screens are displayed only when HEAD CHECK is set to ENABLE.
ALL: Perform head check on each item.
CHECK LABELS: Perform head check according to the specified quantity of
head check.
START-END: Perform head check before starting print job and while pausing
print job.
The initial setting is ALL.
Note:
Motion 1 (Backfeed after printing): Perform head check before starting print job
and after backfeed.
Motion 2 (Backfeed before printing): Perform head check before and after
backfeed.
Setting the frequency of head check. Head check is performed every time you
print out the specified number of media.
This screen is displayed only when HEAD CHECK MODE is set to CHECK
LABELS.
Press the LINE button to change the setting value and press the FEED button
to move the cursor to the next digit.
Setting range is between 000001 to 999999.
The initial value is 000001.
Setting the auto online function during printer start up.
This function sets the printer status at the time of power on.
ENABLE: Starting up the printer in online mode.
DISABLE: Starting up the printer in offline mode.
The initial setting is ENABLE.
Description
CW408 Operator Manual