Warning Messages - SATO CW408 Operator's Manual

Preliminary
Section 5: Troubleshooting
5.1 ERROR SIGNAL TROUBLESHOOTING (Cont'd)

5.1.4 Warning Messages

Note that the printer will continue issuing media while detecting a warning message.
No. WARNING DISPLAY
01 BUFFER NEAR FULL
ONLINE
000000
02 COMMAND ERROR
ONLINE
000000
03 HEAD ERROR
ONLINE
000000
04 PRINT PAUSE
PAUSE
Page 5-6
LED/ BUZZER ERROR CONDITION
ONLINE: On 1) Available space for receive
buffer is low.
ERROR: Blinks
No beep sound
ONLINE: On 1) Command error was
detected.
ERROR: Off
2) Print ratio per media
exceeded 50% (416 dots)
when using print darkness
level B.
1 short beep
• This screen appears only
when DISPLAY ERROR is
set to DISABLE in
Advance settings mode.
To clear error: The Icon will
be cleared when receiving
next item or cancelling the
job.
ONLINE: On 1) Detected print head dam-
age with "STANDARD"
ERROR: Off
HEAD CHECK and contin-
ued printing operation
using "BARCODE" HEAD
CHECK.
To clear error: Power off
No beep sound
(Print head replacement)
ONLINE: Blinks 1) Print ratio per one media
exceeded certain level.
ERROR: Off
No beep sound
CORRECTIVE ACTION
1) Do not send the data from the
host until the analysis of
received data is completed.
1) Confirm print data.
2) Adjust print layout so that print
ratio is lower than 50%.
1) Replace print head.
1) Wait for a while.
CW408 Operator Manual