Interface Setting Mode - SATO CW408 Operator's Manual

Preliminary
Section 3: Operation and Configuration

3.10 INTERFACE SETTING MODE

In this mode, you can set various parameters governing the use of different interfaces.
LINE + FEED button
for more than 3 secs
LINE + FEED button
for more than 3 secs
LINE + FEED button
for more than 3 secs
1. When the printer is in OFFLINE mode, press and hold the LINE and FEED buttons simultaneously for
more than three seconds. The printer switches to SETTING MENU mode. Then press the LINE button
twice to display I/F SETTINGS menu and press the FEED button to enter the menu.
2. INTERFACE SELECT is displayed first. Press the FEED button to switch to the next setting options as
shown above. To return to the previous setting option, press the LINE and FEED buttons simultaneously.
To return to the I/F SETTINGS screen, press and hold the LINE and FEED buttons simultaneously for
more than three seconds.
3. When the desired setting option is displayed, press the LINE button to select the item. Then press the
FEED button to save the setting and move to the next screen.
Page 3-18
SETTING MENU
I/F SETTINGS
SKIP SELECT
FEED button
LINE + FEED button
I/F SETTINGS
INTERFACE SELECT
I/F SETTINGS
AUTO SELECT
INTERFACE SELECT
I/F SETTINGS
USB
INTERFACE SELECT
LAN
FEED button
LINE + FEED button
I/F SETTINGS
PROTOCOL
I/F SETTINGS
STATUS4
PROTOCOL
STATUS3
FEED button
LINE + FEED button
I/F SETTINGS
REPLY TIMING
I/F SETTINGS
ENQ
REPLY TIMING
CYCLE
FEED button
* Press the LINE button to select an item.
* Press the FEED button to save the setting and
move to the next screen.
* Press and hold the LINE and FEED buttons
simultaneously for more than three seconds to
revert to the I/F SETTINGS menu.
These screens are
displayed only when AUTO
SELECT or LAN is
selected for INTERFACE
SELECT menu.
These screens are
displayed only when
STATUS4 is selected for
PROTOCOL menu.
CW408 Operator Manual