SATO CW408 Operator's Manual page 24

Preliminary
Section 2: Installation
2.4 HOW TO LOAD THE MEDIA (cont'd)
5.
Pull down the media guide lever of the printer to
release the media guide. Adjust the media guide to the
media size.
6.
Set the printer power to on and insert the leading edge of
the media into the media feed inlet of the printer. The
printer will activate the Automatic media feed function.
Refer to Section 2.4.1 Automatic Media Feed Func-
tion for more details.
Notes:
• Make sure that the printed side of the media is facing
upwards.
• Make sure that the length of the media is at least
130 mm (5.1") long for proper media detection.
• When the automatic media feed function is enabled
in tear-off or cutter mode, the position of the first
media is not correctly set. Press the FEED button in
offline mode to adjust the position.
Page 2-10
Printed side
should face upwards
CW408 Operator Manual