Easy Replacement Of Parts; How To Replace The Print Head - SATO CW408 Operator's Manual

Preliminary
Section 4: Cleaning and Maintenance

4.4 EASY REPLACEMENT OF PARTS

It is easy to replace the print head and platen roller of the CW408 printer.
The one-touch, tool-less print head release mechanism enables the print head to be quickly and easily
replaced. The platen roller can be replaced without use of any tools.

4.4.1 How to Replace the Print Head

The print head on the printer is a user-replaceable item. If it becomes damaged for any reason, it can be
easily removed and replaced. Contact your SATO reseller or technical support center for information on
obtaining a new print head.
Caution
• Static electricity can result in component damage. Observe appropriate grouping procedures
when replacing any components.
• Wear protective gloves to avoid contaminating the sensitive print head surface.
1.
Make sure that the printer is set to off, and remove the AC
power cord.
2.
Lift the top cover.
3.
While pressing on the two sides of the print head assem-
bly , slide the print head assembly downward to
1
unlock.
Make sure that the latch
assembly is unlocked.
4.
Lift and pull out the print head assembly
reveal the wiring harnesses
5.
Disconnect the wiring harnesses
print head to remove the defective print head.
6.
Carefully connect the wiring harnesses to the new print
head. The connectors are keyed so that they can only be
inserted in the correct orientation.
Caution:
While handling the print head, be careful not to scratch
the printing surface of the print head. Scratching the
surface will cause permanent and irreparable damage
that is not covered by the warranty!
Page 4-4
on the side of the print head
2
a little to
3
.
4
on both sides of the
4
2
1
3
CW408 Operator Manual
4