How To Replace The Platen Roller - SATO CW408 Operator's Manual

Preliminary
4.4 EASY REPLACEMENT OF PARTS (cont'd)
7.
Insert the shaft
4 5
the hole on the left side of top cover.
8.
Press on both sides of the print head assembly
slide upwards to lock the print head assembly in
7
place.
Make sure that the latch
assembly is locked.
9.
Close the top cover.
10.
Restore power, reload media, reset the head counter and
perform a test print to make sure that the print head is
connected properly.

4.4.2 How to Replace the Platen Roller

1.
Make sure that the printer is set to off, and remove the AC
power cord.
2.
Lift the top cover.
3.
Locate the dispenser bar
, and flip the dispenser bar
2
shown.
4.
Lift the dispenser bar
roller assembly and replace it with a new one.
5.
Follow the above steps, in reverse sequence, to
reassemble the new platen roller. Make sure that the
dispenser bar snaps back in position.
Perform a media feed to make sure that the platen roller is
assembled correctly.
CW408 Operator Manual
of the new print head assembly into
on the side of the print head
2 8
in front of the platen roller
1
in the direction as
3
to remove the defective platen
4
Section 4: Cleaning and Maintenance
8
and
6
1
7
6
7
6
5
2
3
4
Page 4-5