SATO CW408 Operator's Manual page 92

Preliminary
Section 6: Basic Specifications
PRINT
Method
Print Speed (Selectable)
Resolution
Non-printable Area
Maximum Print Width
Maximum Print Length
Print Darkness
MEDIA
(Be sure to use media manufactured or certified by SATO)
Size
Type
Roll Diameter (Media Roll)
Core Diameter (Media Roll)
Page 6-2
2 to 6 Inch/sec (50.8 to 152.4 mm/sec)
(Setting value: 2, 3, 4, 5, 6 IPS)
*When using with dispenser, the print speed will be up to 4 inch/sec (100 mm/sec).
*Print speed varies depending on the media used.
8 dots/mm (203 Dots Per Inch)
Pitch direction Top: 1.5 mm (0.06") or less (exclude liner)
Bottom: 1.5 mm (0.06") or less (exclude liner)
Width direction Left: 1.5 mm (0.06") or less (exclude liner)
Right: 1.5 mm (0.06") or less (exclude liner)
* There are 10 levels of print darkness such as "1A ~ 10A". Default is 5A.
*Command error occurs when the print ratio per one line in B range exceeds 50%
(417 dots). Check the print layout before printing.
Continuous
Tear-off
Cutter
Dispenser
Single label
print
Use media roll, fan-fold media or single label specified by SATO.
Maximum outer diameter 115 mm (4.5")
Direct Thermal
104 mm (4.1")
400 mm (15.7 ")
Darkness range: A, B
Darkness level: 1 to 10
Width: 25 to 115 mm (1.0" to 4.5")
Width including liner: 28 to 118 mm (1.1" to 4.6")
Pitch: 25 to 397 mm (1.0" to 15.6")
Pitch including liner: 28 to 400 mm (1.1" to 15.7")
Width: 25 to 115 mm (1.0" to 4.5")
Width including liner: 28 to 118 mm (1.1" to 4.6")
Pitch: 25 to 397 mm (1.0" to 15.6")
Pitch including liner: 28 to 400 mm (1.1" to 15.7")
Width: 25 to 115 mm (1.0" to 4.5")
Width including liner: 28 to 118 mm (1.1" to 4.6")
Pitch: 25 to 397 mm (1.0" to 15.6")
Pitch including liner: 28 to 400 mm (1.1" to 15.7")
Width: 25 to 115 mm (1.0" to 4.5")
Width including liner: 28 to 118 mm (1.1" to 4.6")
Pitch: 25 to 100 mm (1.0" to 3.9")
Pitch including liner: 28 to 103 mm (1.1" to 4.1")
Width: 25 to 115 mm (1.0" to 4.5")
Width including liner: 28 to 118 mm (1.1" to 4.6")
Pitch: 127 to 397 mm (5.0" to 15.6")
Pitch including liner: 130 to 400 mm (5.1" to 15.7")
Direct thermal
Inner core diameter 40 mm (1.6")
CW408 Operator Manual