SATO CW408 Operator's Manual page 58

Preliminary
Section 3: Operation and Configuration
3.14 TEST PRINT MODE (Cont'd)
Printed Item Name
Factory TearOff
Factory ALF
Sensor Type
Option Unit
Sensor1
Low [Lo<0.6]/
High [0.9<Hi-Lo]/
Slice Level
Adjust Level(Emit)
Adjust Level(Recv)
Sensor2
Slice Level
Adjust Level(Recv)
Page 3-32
Item Name
Tear off position adjustment
value for factory setting
ALF position adjustment value
for factory setting
Sensor type
Installed option
Sensor type
Sensor level
Sensor type
Sensor level
Description
±xx(dot)
±xx(dot)
Printing the selected sensor type.
I-mark: Reflective sensor
Gap: Transmissive sensor
Cutter/ Dispenser/ None
Reflective, Transmissive
The sensor level selected by the sensor type will be
shown.
1. When the sensor is disabled, Low/High will be
indicated as "None".
2. When the slice level is automatic, it will be indi-
cated as "Auto".
3. When the slice level is not automatic, Low/High
will be indicated as "----".
4. When Low/High levels are outside the specified
range, they will be highlighted.
Paper Check
The sensor level selected by the sensor type will be
shown.
1. When the slice level is automatic, it will be indi-
cated as "Auto".
CW408 Operator Manual