Adjusting The Paper End Sensor - SATO S84 Operator's Manual

5.5.4

Adjusting the Paper End Sensor

This printer uses an I-mark sensor to sense the Paper end error.
The checking and adjustment procedures for the Paper end (I-mark) sensor level are as follows:
1
Go to the SENSOR LEVEL I-MARK(R)
setting screen of SERVICE MODE.
First, check the I-MARK(R) value (voltage) of the Paper end (I-mark) sensor when the
liner is placed on the sensor.
2
Open the top cover and unlock the media
feed and media sensor assembly .
3
Physically place the liner  without the
label resting over the I-mark sensor.
4
Press the media feed and media sensor
assembly  down to lock it.
To get the correct adjustment result, close the
media sensor assembly before performing the
adjustment.
5
Check if the I-MARK(R) value is 2.0 V or
lower.
If not, change ADJUST LEVEL using the
buttons until the I-MARK(R) value is 2.0 V or lower.
5 Cleaning and Performing Printer Adjustments
1
2
/
I-mark sensor
I-MARK(R) level: ≤ +2.0V
S84-ex/S86-ex Operator Manual
193