Dodge RAM TRUCK 1500 1995 Service Manual page 217

B R
ALL-WHEEL ANTILOCK BRAKE SYSTEM (ABS) 5 - 45
REAR
BRAKE
HOSE
REAR
SENSOR
HARNESS
CONNECTOR
REAR
SENSOR
REAR
AXLE
HOUSING
J9405-81
Fig. 20 Rear Speed Sensor Harness Routing And Attachment
SENSOR
HARNESS
CONNECTOR
SENSOR
HARNESS
HOSE
UCLIP
J9405-92
Fig. 21 Disengaging Harness Connector At Rear
Sensor
ment is used, it is important that the manufacturers
instructions be followed for proper results.
Vacuum bleeding does not require that the front
brake metering valve be held open. However, if pres­
sure equipment is used, it will be necessary to hold
the front brake metering valve open in order to bleed
the front brakes. The valve can be held open with a
tension clip tool or by hand. It will also be necessary
that a suitable size pressure tank hose adapter be
available for use on the master cylinder reservoir
caps.
Recommended bleeding sequence is:
• master cylinder
• rear antilock valve
• combination valve
J9405-93
Fig. 22 Sensor Rear Harness Attachment
• front antilock valve
• left rear wheel
• right rear wheel
• right front wheel
• left front wheel
Observe following precautions while bleeding the
brake system:
® Bleed only one valve, or wheel brake unit at a
time. Use a bleed hose on each wheel cylinder and
caliper bleed screw.
• Attach one end of the bleed hose to the bleed