Dodge RAM TRUCK 1500 1995 Service Manual page 435

B R
INSTRUMENT PANEL ANi GAUGES 8E - 21
DOOR
STOP
Fig. 22 Headlamp Switch Knob and Stem Remove/
Install
OVERDRIVE LOCKOUT/FOG
L A M P
SWITCH BEZEL
REMOVE SCREWS
J 9 5 8 E - 4 7
Fig. 23 Overdrive Lockout/Fog Lamp Switch
Remove/Install
(5) Reverse removal procedures to install.
GLOVE BOX REMOVE/INSTALL
(1) Open glove box door. Depress right side of bin
enough to allow stop to clear opening (Fig. 24).
(2) From inside glove box, push on stem of button
holding strap at left end of door. Button will push out
allowing strap to be removed.
(3) The door and bin are removed by lifting door
off hinges (Fig. 25).
(4) Reverse removal procedures to install.
GLOVE BOX LAMP/SWITCH/LATCH STRIKER
REMOVE/INSTALL
(1) Open glove box until stops in bin rest against
instrument panel.
(2) To remove lamp and switch, grasp switch by
plunger and pull firmly outward. Switch and lamp
GLOVE BOX DOOR
J948E-20
Fig. 24 Glove Box Door Release
• GLOVE BOX ™T^J/
J948E-21
Fig. 25 Glove Box and Bin Remove/Install
assembly are retained in mounting hole by a light
snap fit. To remove latch striker, remove 2 screws
(Fig. 26).
REMOVE
SCREWS
J948E-18
Fig. 26 Glove Box Lamp/Switch - Typical
(3) Disconnect wires to switch and lamp (Fig. 27).
(4) Remove bulb from socket.