Dodge RAM TRUCK 1500 1995 Service Manual page 407

80 - 34 IGNITION SYSTEMS
B R
KEY-IN SWITCH &
HALO LIGHT
MULTI-FUNCTION
SWITCH
BRACKET
I G N I T I O N
SWITCH
RETAINING
SCREW
TURN S I G N A L
SWITCH & LEVER
SPEED
CONTROL
J918J-2
Fig. 4 Key-In-Switch and Halo Lamp Connector
BRACKET
RETAINING
SCREW
958D-62
Fig. 5 Key Cylinder Retaining Screw
INSTALLATION
(1) Connect electrical connectors to ignition switch.
Make sure that switch locking tabs are fully seated
in wiring connectors.
(2) Before attaching ignition switch to a tilt steer­
ing column, the transmission shifter must be in Park
position. The park lock dowel pin and column lock
flag must also be properly indexed before installing
switch (Fig. 9).
(a) Place transmission shifter in PARK position.
(b) Place ignition switch in lock position. The
switch is in the lock position when column lock flag
is parallel to ignition switch terminals (Fig. 9).
(c) Position ignition switch park lock dowel pin
so it will engage steering column park lock slider
linkage (Fig. 10).
958D-63
Fig. 6 Key Cylinder Retaining Screw
KEY CYLINDER
BEZEL
j HALO LIGHT
R I N G
908D-16
Fig. 7 Unseated Key Cylinder
(d) Apply a light coating of grease to column lock
flag and park lock dowel pin.
(3) Place ignition switch against lock housing open­
ing on steering column. Ensure that ignition switch
park lock dowel pin enters slot in park lock slider
linkage in steering column.
(4) Install retaining bracket and ignition switch
mounting screws. Tighten screws to 3±.5 N-m (26±4
in. lbs.) torque.
(5) Install ignition lock cylinder: