Dodge RAM TRUCK 1500 1995 Service Manual page 166

3 - 46 BEAR SUSPENSION AND AXLE
B R
SOCKET
DISC
C-4487-1
Fig, § Threaded Adapter Installation
SPECIAL
Fig. 10 Remove Pinion Thrust Washer
GLEAMING AND INSPECTION
(1) Clean all components in cleaning solvent. Dry
components with compressed air.
(2) Inspect clutch pack plates for wear, scoring or
damage. Replace both clutch packs if any one compo­
nent in either pack is damaged.
(3) Inspect side and pinion gears. Replace any gear
that is worn, cracked, chipped or damaged.
(4) Inspect differential case and pinion shaft. Re­
place if worn or damaged.
Fig. 11 Pinion Gear Removal
SIDE GEAR DIFFERENTIAL
AND CLUTCH DISC CASE
Fig. 12 Side Gear & Clutch Disc Removal
PRESOAK PLATES AND DISC
Plates and disc with fiber coating (no groves or
lines) must be presoaked in Friction Modifier before
assembly. Soak plates and discs for a minimum of 20
minutes. Add remaining Friction Modifier to differen­
tial after assembly.
ASSEMBLY
(1) The clutch discs are replaceable as complete
sets only. If one clutch disc pack is damaged,