Dodge RAM TRUCK 1500 1995 Service Manual page 452

HORNS 8G - 3
SERW1CE PROCEDURES
HORN SWITCH REMOVE/INSTALL
WARNING: B E F O R E BEGINNING ANY A I R B A G S Y S ­
TEM COMPONENT REMOVAL OR INSTALLATION,
REMOVE AND ISOLATE THE NEGATIVE (-) C A B L E
FROM THE BATTERY. THIS IS THE ONLY S U R E
WAY TO D I S A B L E THE A I R B A G S Y S T E M . FAILURE
TO DO THIS COULD R E S U L T IN ACCIDENTAL AIR-
BAG DEPLOYMENT AND P O S S I B L E INJURY. WAIT 2
MINUTES FOR THE A I R B A G S Y S T E M CAPACITOR
TO DISCHARGE B E F O R E REMOVING OR W O R K I N G
ON ANY A I R B A G S Y S T E M COMPONENTS.
(1) Disconnect battery negative cable.
(2) From underside of steering wheel, remove speed
control switch or trim bar mounting screws (Fig. 2).
SPEED CONTROL
SWITCHES
IBf J948H-9
Fig. 2 Speed Control Switch/Trim Bar Remove/install
(3) Pull switch/trim bar from wheel and unplug
connector (Fig. 3).
(4) Using a small screwdriver remove right rear
steering wheel cover (Fig. 4).
RIGHT
REAR
STEERING
! WHEEL COVER
J948G-1
Fig. 4 Right Rear Steering Wheel Cover Remove/
Install
(5) Remove 4 nuts attaching airbag module (Fig.
5).
SPiEP CONTROL
SWITCHES
J948G-2
J94SH-8
Fig. 5 Airbag Module Remove/Install
Fig. 3 Speed Control Switch Connector Remove/install
(6) Remove airbag module from steering wheel.