Dodge RAM TRUCK 1500 1995 Service Manual page 434

SE - 24 INSTRUMENT PANEL AND GAUGES
B R
HEATER - A/C CONTROL/MESSAGE CENTER
REMOfE/INSTALL
(1) Remove cluster bezel as described in Cluster
Bezel Remove/Install.
(2) Remove 4 control attaching screws (Fig. 19).
Fig. 19 Heater - A/C Control/Message Center
Remove/install
(3) Pull control rearward.
(4) Unplug 2 wiring harness connectors (Fig. 20).
Fig. 20 Heater - A/C Control/Message Center
Connections
(5) Push in on red cable connector to release. Re­
move cable end from control unit.
(6) Remove control.
(7) Reverse removal procedures to install.
HEATER - A/C CONTROL/MESSAGE CENTER LAMP
BULBS REMOVE/INSTALL
(1) Remove heater - A/C control/message center as
described in Heater - A/C Control/Message Center
Remove/Install.
(2) Twist lamp socket assembly and remove from
printed circuit board.
(3) Remove bulb from socket.
(4) Install correct replacement bulb in socket.
(5) Reverse removal procedures to install.
HEADLAMP SWITCH REMOVE/INSTALL
WARNING: IF HEADLAMP SWITCH WAS ON, WAIT 5
MINUTES TO ALLOW THE CERAMIC DIMMER TO
COOL. IF THE CERAMIC DIMMER IS NOT ALLOWED
TO COOL YOU CAN BURN YOUR FINGERS.
(1) Remove cluster bezel as described in Cluster
Bezel Remove/Install.
(2) Remove 3 screws and headlamp switch from in­
strument panel (Fig. 21).
Fig. 21 Headlamp Switch and Bezel Remove/Install
(3) Unplug 2 electrical connectors (Fig. 22).
(4) Pull knob and stem assembly out to stop. De­
press button on bottom of switch and remove knob
and stem from housing.
(5) Remove 2 screws and bezel from housing.
(6) Reverse removal procedures to install.
OVERDRIVE LOCKOUT/FOG LAMP SWITCH
REMOVE/INSTALL
(1) Remove cluster bezel as described in Cluster
Bezel Remove/Install.
(2) Remove 3 screws and remove switch and bezel
unit (Fig. 23).
(3) From rear of switch and bezel unit, pull up on
retaining tab and unplug electrical connector.
(4) Release retaining tabs and remove switch from
rear of bezel.