Dodge RAM TRUCK 1500 1995 Service Manual page 298

7 - 28 COOLING SYSTEM SERVICE PROCEDURES
GENERATOR/COMPRESSOR
AND BRACKET
SUPPORT BRACKET
1 2
IDLER
PULLEY
AUTOMATIC
BELT
TENSIONER
J9307-33
IGNITION
COIL BRACKET
Fig. 30 idler Pulley—3.9L V-6 or 5.2/5.9L V-8
LDC-Gas Engines
of the A/C compressor/generator bracket mounting
bolts. Remove the tensioner mounting bolt (Fig. 31)
and remove tensioner.
PULLEY
BOLT
TENSIONER
MOUNTING
BOLT
TENSIONER J9307-64
Fig. 31 Belt Tensioner—5.9L HDC-Gas Engine
(9) Remove the engine oil dipstick tube mounting
bolt at the side of the A/C-generator mounting
bracket.
(10) Disconnect throttle body control cables. Refer
to Accelerator Pedal and Throttle Cable in Group 14,
Fuel System.
(11) Remove heater hose coolant return tube
mounting bolt (Figs. 32 or 33) and remove tube from
engine. Discard the old tube o-ring.
WATER
PUMP
Fig. 32 Coolant Return Tube—3.9L I
V-8 LDC-Gas Engines
COOLANT
RETURN
TUBE
J9307-34
~6 or 5.2/5.9L
TUBE
MOUNTING
BOLT
WATER PUMP J9307-61
Fig. 33 Coolant Return Tube—5.9L HDC-Gas Engine
(12) Remove bracket-to-intake manifold bolts
(number 1 and 2 Fig. 29).
(13) Remove remaining bracket-to-engine bolts
(Figs. 34 or 35).
(14) Lift and position generator and A/C compres­
sor (along with their common mounting bracket) to