Snmp Config Menu Command - Siemens SCALANCE W788-1PRO Operating Instructions Manual

Configuration Using Web Based Management and the Command Line Interface
6.2.7 SNMP Config Menu Comman
Configurati on
Select the check boxes
to use. SNMP version 3
authenticatio
Users submenus. You
SNM Pv3 enabled chec
Notice
When using SNMP ver
se curity settings of SNMP V3 can be bypassed by access over SNMP V1 or V2c.
Trap Submenu
Here, you enter the IP addresses of up to 10 trap receivers. The SCALANCE W78x
sends a trap to all the addresses you enter if their Enable trap check boxes are
selected.
Note
During a warm or cold restart with a wireless connection ( AP client, WDS, or
WRED), there is no guarantee that the recipient can be reached at the time when
the trap is sent. This leads to a loss of the message.
Groups Submenu
This page displays the SNMPv3 groups. You can create a new group by clicking
the New button and specifying the group name, the security level, and the write or
read permissions.
You can delete a group by selecting the check box in the Del column and clicking
the Set Values button. If members are already entered in the group, you cannot
delete the group nor is it possible to change the security level of the group.
Operating Instructions SCALANCE W78x
C79000-G8976-C184-07
d
of the entries according to
allows permi
n, and enc ryption. You specify groups a
can also make
k box is not selected, however the ntries are not applied.
sion 3, you sho
the SNMP functionality you want
ssions to be assigned and protocol level,
nd us ers in the Groups and
entries there if the
e
uld disable SNMP V1 and V2c because the
122